How to Put a Mower Deck Belt Back on Cub Cadet

* Socket set

* Wrench set

* Pliers

* Flat-head screwdriver

* Philips-head screwdriver

Step 1: Prepare the Mower

- Park your mower on level ground. Engage the parking brake and turn off the engine. Allow it to cool down completely before starting any repairs.

- Raise the mower deck. Consult your owner's manual for specific instructions on how to do this for your model.

Step 2: Remove the Old Belt

- Find the belt tensioner. This is usually located on the side of the mower deck.

- Release the tension on the belt. Use a wrench to loosen the tensioner bolt or use a flat-head screwdriver to push down on the tensioner arm.

- Remove the belt from the pulleys. Start with removing the belt from the engine pulley, then carefully slide the belt off of the other pulleys.

- Discard the old belt. Inspect the old belt for any signs of wear or damage, such as cracks, fraying, or glazing. If the belt is damaged, it is important to replace it with a new one.

Step 3: Install the New Belt

- Route the new belt around the pulleys. Start with putting the belt on the engine pulley, then carefully slide the belt onto the other pulleys. Make sure that the belt is properly seated in the pulley grooves.

- Reattach the belt tensioner. Tighten the tensioner bolt or push up on the tensioner arm until the belt is snug.

- Check for proper tension. The belt should be tight enough to prevent slipping, but not too tight that it puts unnecessary stress on the engine or mower deck.

Step 4: Lower the Mower Deck

- Lower the mower deck. Consult your owner's manual for specific instructions on how to do this for your model.

Step 5: Test the Mower

- Start the mower and engage the blades. Let the mower run for a few minutes to test that the belt is properly installed and functioning correctly.

Tips

* If you are having difficulty removing or installing the mower deck belt, refer to your owner's manual for specific instructions for your model.

* Be careful not to overtighten the belt tensioner, as this can put unnecessary stress on the engine and mower deck.

* If you have any questions about how to replace your mower deck belt, consult with a qualified technician.