How to Install Carpet Tiles from Lowes

Carpet tiles are small squares of carpet that you can install without going through the lengthy and laborious process of stretching carpet. Lowes --- a national home supply center --- sells multiple styles and colors of carpet tiles. Lowes may also provide some guidance on installation, although it is very informal. Like any homeowner project, laying carpet tiles will take some preparation and planning to ensure that the carpet goes down correctly and will remain a fixture in your home for a long time.

Broom
Vacuum
Concrete filler
Wood patch
Weighted floor roller

Instructions

- 1
  Set the carpet tiles in a room next to where you will install them. Allow the tiles to sit for 24 hours so they acclimate to your home's interior environment.
- 2
  Clean the floor before laying the tiles; sweep or vacuum dirt from the floor. Patch holes with concrete filler or wood patch depending on your subfloor material.
- 3
  Measure the length and width of the room to determine its center. Use a chalk line to mark along your measurements to have guidelines for laying the carpet tile.
- 4
  Use a square to ensure the center corners snapped by the chalk line are at 90 degree angles. Re-measure and re-square if needed.
- 5
  Lay four carpet tiles in each quadrant in the center of the room. Peel the backing from the tile and stick them carefully to the floor. Ensure the arrows on the bottom of the carpet tiles are pointing in the same direction.
- 6
  Surround the initial square of carpet tiles with another set of tiles. Attach the carpet tiles according to the directions in Step 5.
- 7
  Continue to lay carpet tiles by surrounding the initial square with additional tiles. Do this until you lay all the carpet tiles.
- 8
  Roll over the tiles with a weighted floor roller to ensure no air bubbles exist between any carpet tiles and the subfloor.

How to Transition Between Carpet & Floor

How do I Install a Lexfloor Soundproof Underlayment?

Carpeting