How to Make a Henna Applicator

Materials Needed:

* Empty plastic bottle (with a squeeze-able top)

* Rubber band

* Toothpick or small brush

Instructions:

Step 1: Clean the Bottle

Thoroughly wash and dry the plastic bottle to ensure there are no residues or moisture.

Step 2: Cut the Bottle Top

Using scissors, carefully cut off the top part of the plastic bottle. The cut should be about 1/2 inch from the top. Make sure the edges are smooth to avoid any discomfort while using the applicator.

Step 3: Add Rubber Band

Take a rubber band and wrap it securely around the cut bottle just below the opening. The purpose of the rubber band is to control the flow of henna paste.

Step 4: Shape the Tip

At the center of the plastic cap, make a small hole using the toothpick or a small brush. This hole will serve as the henna applicator tip.

Step 5: Test the Applicator

Squeeze the bottle gently to test the flow of henna paste. The henna should come out smoothly through the tip without any blockages. If there's too much flow, adjust the rubber band position to limit the flow.

Tips for Using your Henna Applicator:

- For best results, ensure that the henna paste has a smooth, creamy consistency.

- Start by applying small, thin lines to outline your design before filling in larger areas.

- Practice your designs on paper before applying them to your skin.

- Keep your henna applicator tip clean and free of dried henna paste to ensure smooth application.

Remember, henna is a natural dye and can stain skin for several days, so always do a patch test before using it on a larger area of your skin.