How to Decoupage a Poster Wood

_Here's a step-by-step guide to help you get started:_

Materials Needed:

- A poster or image of your choice

- A wooden board or plaque

- Mod Podge or other decoupage medium

- Water

- A paintbrush

- Scissors or a craft knife

- A sanding block or sandpaper

Instructions:

1. Prepare the wooden board: Lightly sand the wooden board to ensure it is smooth and free from any rough edges.

2. Cut out the poster image: Carefully cut out the image you want to decoupage from the poster, leaving a small border around the edge.

3. Apply Mod Podge: Spread a layer of Mod Podge onto the wooden board using the paintbrush. Be sure to cover the entire surface.

4. Place the poster image: Position the cut-out poster image onto the Mod Podge-covered board. Smooth out any bubbles or wrinkles using your fingers or a flat tool.

5. Apply more Mod Podge: Apply another layer of Mod Podge over the poster image, covering the entire surface. This will help to seal and protect the image.

6. Let dry: Allow the project to dry completely. The drying time will depend on the type of Mod Podge used.

7. Sand the edges: Once the project is dry, lightly sand the edges of the poster image to blend them in with the wooden board.

8. Add a topcoat: If desired, you can apply a final topcoat or sealer to protect the project and add a glossy or matte finish.

_Your decoupaged poster wood is now complete and ready to be hung up or displayed._