How to Use Grease on Drawer Slides

Materials Needed:

- Grease (Lithium-based or silicone grease is commonly used)

- Clean cloth

- Screwdriver (if necessary)

Instructions:

Step 1: Remove the Drawer:

- Open the drawer fully and locate the drawer slides underneath.

- Unscrew the screws or release the latches that hold the drawer in place.

- Carefully pull out the drawer, taking note of the position and orientation of the drawer slides.

Step 2: Clean the Drawer Slides:

- Use a clean cloth to wipe away any dirt, debris, or old grease from the drawer slides.

- Make sure the slides are free from obstructions and grime to ensure proper lubrication.

Step 3: Apply Grease:

- Take the grease and use your finger or a small brush to apply a thin coat of grease onto the surfaces of the drawer slides.

- Pay close attention to the contact points where the drawer slides against the drawer.

- Avoid over-greasing as it may attract dust and debris, leading to reduced effectiveness over time.

Step 4: Reinsert the Drawer:

- Carefully align the drawer slides and insert the drawer back into its original position.

- Secure the drawer by tightening the screws or reattaching the latches.

Step 5: Test the Movement:

- Open and close the drawer a few times to check the smoothness of its movement.

- If the drawer slides easily and without any resistance, the lubrication was successful.

Step 6: Periodic Maintenance:

- Repeat this greasing process every few months or as needed to maintain smooth drawer operation and prevent wear and tear.

Remember to use the appropriate type of grease for drawer slides. Some materials may react poorly to certain greases, so always refer to the manufacturer's instructions or recommendations for the best results.