How to Repair a PEX Pipe

Gather your tools and materials. You will need:

- A PEX pipe cutter

- A PEX crimp tool

- A PEX coupling

- Two PEX insert rings

- A sharp utility knife

- Sandpaper

- A tape measure

- A permanent marker

1. Turn off the water supply.This is the most important step, as it will prevent water from leaking out of the pipe while you are working.

2. Cut the damaged section of pipe.Use the PEX pipe cutter to make a clean, square cut.

3. Sand the ends of the pipe.This will help to remove any burrs or rough edges that could prevent the PEX coupling from fitting properly.

4. Install the PEX insert rings.Slide the PEX insert rings onto the ends of the pipe. Make sure that the rings are fully seated on the pipe.

5. Insert the PEX coupling.Push the PEX coupling onto the ends of the pipe until it is fully seated.

6. Crimp the PEX coupling.Use the PEX crimp tool to crimp the coupling in place. Be sure to crimp the coupling according to the manufacturer's instructions.

7. Turn on the water supply.Check for leaks by turning on the water supply and inspecting the repaired area.

That's it! You have now successfully repaired a PEX pipe.

Here are some additional tips for repairing a PEX pipe:

- Be sure to use the correct size PEX coupling for your pipe.

- Tighten the PEX coupling until the crimp rings are just flush with the edge of the pipe.

- If you are repairing a pipe that is under pressure, be sure to relieve the pressure before starting work.

With a little care and attention, you can easily repair a PEX pipe and get your plumbing system back up and running in no time.