# How to Replace the Seal Housing on a Magnum Force Jacuzzi
The Magnum Force is a hot tub pump manufactured by Jacuzzi. The Magnum Force pump is held inside what is known as the pump housing. The pump housing is enclosed and secured by a rubber seal. If leakage is observed it may be time to change the seal. This involves removing the old seal and securing a new one in place.
Things You'll Need
- Phillips screwdriver
- Replacement seal
- Marine silicone
Instructions
-
-
1
Turn the power off to the pump at the circuit breaker.
-
2
Remove the screws at the base of the seal or pump housing.
-
3
Lift the housing upwards to access the old seal. Remove it by hand or, if necessary, use a plastic putty knife to pry it away.
-
4
Use a gentle spray cleaner and wipe off any sticky or gummy residue from the old seal.
-
5
Apply a bead of marine silicone along the perimeter of the seal and then press it in place carefully around the bottom of the pump housing.
-
6
Set the pump housing back in place and then replace the retaining screws.
-
7
Return power to the Magnum Force by flipping the breaker back on.
-
1
Previous:
Lawn Ornaments
- How to Replace the Gasket Seal on a Dacor Oven
- How to Replace the Hub Seal on an Amana ALW880QAW
- How to Replace the Clip on a Washing Machine's Clutch
- How to Replace the Wash Pump in an Electrolux Dishwasher
- How to Replace the Filter Housing on a Frigidaire FRS26ZRF
- How to Replace the Seal on a Kenmore Front
- How to Replace the Water Pump in a Carpet Shampooer
- How to Replace the Pump on a Troy-Bilt Pressure Washer
- How to Replace the Front Door Seal on an LG
- How to Replace the Door Boot Seal on an LG
- How to Replace the Moisture Seal in a Bathtub
- How to Measure to Replace the Seal on a Shower Door
