How to Make a Birch Branch Menorah

- 9 birch branches, each about 12 inches long

- 9 tea light candles

- A drill

- A 1-inch spade bit

- A saw

- A miter box

- Sandpaper

- A clear sealant

Instructions:

1. Cut the birch branches to the desired length.

2. Use the drill and spade bit to make a 1-inch hole in the center of each branch, about 2 inches from the top.

3. Use the saw and miter box to cut the tops of the branches at a 45-degree angle.

4. Sand the branches to smooth out any rough edges.

5. Apply a clear sealant to the branches to protect them.

6. Place a tea light candle in each hole.

Tips:

- If you don't have a drill, you can use a sharp knife to make the holes in the branches.

- If you don't have a saw and miter box, you can use a handsaw and a straight edge to cut the tops of the branches at a 45-degree angle.

- Be sure to sand the branches thoroughly to remove any rough edges.

- Apply the clear sealant to the branches in a well-ventilated area.

- Allow the sealant to dry completely before placing the tea light candles in the holes.

Your birch branch menorah is now complete!