Stretch a chalk snap line across the slab to mark a line that indicates the outer faces of the fence's posts; do not position the snap line to indicate the posts' center line. Pull the line taut and snap the twine to mark the position. Stretch a tape measure along the chalk line and use a pencil to mark the position of each post along the fence's length, typically 6 to 8 feet apart on center.
Align a square with a pencil mark that indicates the position of a post. Use the square and a pencil to draw a perpendicular line that indicates the inner, adjacent face of the post. Use the pencil and square to create a perpendicular layout line for each of the fence's posts.
Align a post bracket with the layout lines that indicate the faces of a post. While holding the bracket in position, press a pencil through the bracket's bottom screw holes and mark the position of the screw hole on the slab's surface. Lay out screw hole positions for all the posts.
Mount a masonry drill bit to the combination hammer drill and switch the drill to the hammer setting. Wrap electrical tape around the bit's shaft to indicate the desired depth of the screw hole; concrete screw manufacturers include depth guidelines on concrete screw packaging. Bore through the screw holes marked for each post until the electrical tape reaches the slab's surface. Remove concrete dust from the holes with air blasts from an air compressor or cleaning with a tube brush.
Attach a driver bit to the combination hammer drill and switch the drill to the drill and driver setting Position a post bracket over the screw holes. Press the tip of a concrete screw through the bracket and into the screw hole. Drive the screw into the screw hole to secure the bracket to the slab. Secure the post brackets to the slab by driving screws through all the brackets' screw holes.
Lay out the position of the brackets' bolt holes onto the end of the fence posts with a tape measure, pencil and square. Attach a wood drill bit to the drill and switch the drill to the drill and driver setting. Use the drill to bore bolt holes through the bottom of each fence post.
Hoist a post into a post bracket. Align the post's bolt holes with the bracket's bolt holes. Run bolts through the bracket's bolt holes and through the post until the bolts' threaded ends protrude from the opposite side of the bracket. Place a washer over the threaded ends of the bolts and thread nuts onto the bolts. Tighten the nuts first by hand and finish tightening with adjustable wrenches. Hoist and bolt remaining posts into place.