How to Create a V Groove in Wood

* Wood

* Circular saw

* Table saw

* Dado stack

* Featherboard

* Safety goggles

* Ear protection

* Dust mask

Step 2: Cut the Wood

1. Cut the wood to the desired length and width.

2. If the wood is not already straight, you will need to rip it to a straight edge.

3. Make sure the circular saw blade is sharp and set to the correct depth for the desired groove depth.

Step 3: Set up the Table Saw

1. Install the dado stack on the table saw according to the manufacturer's instructions.

2. Adjust the height of the dado stack so that the teeth are just cutting through the wood surface.

3. Attach the featherboard to the table saw fence near the dado stack. This will help to keep the wood from moving during cutting.

Step 4: Cut the Groove

1. Place the wood against the featherboard and slowly push it through the dado stack.

2. Be sure to keep the wood flat against the table saw bed and the featherboard.

3. Continue cutting until you reach the desired groove length.

Step 5: Finish the Groove

1. Once the groove is cut, use a piece of sandpaper to smooth out any rough edges.

2. You can also use a router or chisel to add a chamfer or round over to the edges of the groove.

Tips

* When cutting the groove, be sure to use a sharp dado stack to avoid tear out.

* If the groove is too wide, you can use a shim to narrow it.

* If the groove is too deep, you can use a filler to fill it in.