How to Attach a Stainless Steel Braided Hose Copper Water Pipe

Tools Needed:

1. Adjustable wrench

2. Teflon tape

3. Pipe cutter or hacksaw

4. Union coupling (if needed)

Instructions:

1. Turn off the water supply: Locate the main water shutoff valve for your home and turn it off to prevent water damage during the repair process.

2. Prepare the copper water pipe:

- If the existing copper pipe is too short, you can extend it using a union coupling. However, if it's long enough, you can skip this step.

- Cut the copper water pipe to the desired length using a pipe cutter or hacksaw. Make sure the cut is clean and straight.

- Remove any burrs or sharp edges from the cut end of the pipe using a file or sandpaper.

3. Apply Teflon tape:

- Wrap several layers of Teflon tape clockwise around the male threaded end of the copper pipe. This helps create a watertight seal when connecting to the hose.

4. Attach the stainless steel braided hose:

- Screw the female end of the stainless steel braided hose onto the male threaded end of the copper pipe. Turn it clockwise until it is hand-tight.

5. Tighten the connection:

- Use an adjustable wrench to tighten the connection between the hose and the copper pipe. Ensure it's secure, but avoid overtightening to prevent damaging the threads.

6. Turn the water supply back on:

- Go to the main water shutoff valve again and turn the water supply back on.

- Check for any leaks at the connection between the stainless steel braided hose and the copper pipe. If you notice any drips or leaks, tighten the connection further.

7. Test the connection:

- Turn on the faucet or fixture connected to the repaired section. Let the water run for a few minutes to check for any persistent leaks. If you still notice leaks, you might consider contacting a professional plumber for assistance.

And that's it! You've successfully attached a stainless steel braided hose to a copper water pipe.