Home Garden

How to Drain Gas From a Rigid Pressure Washer

Draining the fuel from your pressure washer is an essential step before performing any maintenance or storage tasks. To ensure safe and efficient draining, follow these steps:

1. Safety Precautions:

- Wear appropriate safety gear such as gloves and eye protection.

- Ensure the pressure washer is turned off and has had enough time to cool down.

2. Locate the Fuel Tank:

- Identify the fuel tank of your rigid pressure washer. It's typically a plastic or metal container located near the engine.

3. Remove the Fuel Cap:

- Unscrew the fuel cap and let any residual pressure escape before proceeding to the next step.

4. Connect a Fuel Hose:

- Attach one end of a clear, flexible fuel hose (usually included with the pressure washer) to the fuel tank's drain plug.

- Make sure the hose is long enough to reach the draining container without any kinks or bends.

5. Position the Draining Container:

- Place a suitable container beneath the end of the fuel hose where it will drain. This could be a fuel-approved container, a gas can, or a large bucket.

- Ensure the container has enough capacity to hold all of the fuel from the pressure washer's tank.

6. Open the Drain Plug:

- Locate and carefully open the drain plug on the fuel tank. It's usually a small screw or valve-type fitting.

7. Drain the Fuel:

- Allow the fuel to drain completely into the container by gravity.

- You may need to tilt or move the pressure washer slightly to facilitate complete drainage.

8. Close the Drain Plug:

- Once all the fuel has drained out, securely tighten the drain plug to prevent any spills or leaks.

9. Dispose of the Fuel:

- Empty the fuel from the container into a proper disposal facility in accordance with local regulations.

- Do not dispose of fuel or fuel containers in household trash or drains.

10. Reattach the Fuel Cap:

- Replace the fuel cap on the pressure washer's fuel tank.

11. Clean Up:

- Clean any spills or residue around the pressure washer and fuel container with a suitable solvent or detergent.

By following these steps, you can safely and effectively drain the gas from your rigid pressure washer, ensuring proper maintenance and storage practices.