How to Replace a Fuse in Hager Box

Turn off the Main Power:

Before you begin working on the fuse box, ensure that the main power supply to the house or apartment is turned off. This can usually be done by flipping the main circuit breaker to the "Off" position.

Open the Hager Box:

Locate the Hager box, which is typically mounted on a wall in the basement, garage, or utility area. Open the box by pressing the release button or sliding the latch.

Identify the Faulty Fuse:

Inside the Hager box, you will find an array of fuses. Each fuse is labeled with its amperage rating. Check each fuse visually to identify the one that has blown. A blown fuse will have a broken filament or a dark discoloration.

Remove the Faulty Fuse:

To remove the faulty fuse, use a pair of needle-nose pliers to grasp the fuse by its metal end caps and gently pull it out of its holder. Be careful not to touch the live terminals inside the fuse box.

Install the New Fuse:

Take a new fuse of the same amperage rating as the blown fuse and insert it into the empty fuse holder. Press the fuse in firmly until it clicks into place.

Close the Hager Box:

Once the new fuse is installed, close the Hager box by sliding the latch or pressing the release button.

Turn on the Main Power:

Finally, turn the main power supply back on by flipping the main circuit breaker to the "On" position. The power should now be restored to the circuit that was affected by the blown fuse.

Testing the Circuit:

Turn on the lights or appliances connected to the circuit that had the blown fuse. If they work correctly, the fuse replacement was successful.

Safety Precautions:

Always remember to turn off the main power before working on any electrical components. If you are uncomfortable working with electrical systems, it is recommended to consult a qualified electrician for assistance.

By following these steps, you can safely and easily replace a fuse in a Hager box and restore power to the affected circuit.