How to Make Tile Photo Coasters

- Blank ceramic tiles (4x4 inches)

- Photos printed on photo paper

- Mod Podge

- Foam brush

- Scissors

- Pencil

- Ruler

- Wax paper

- Felt (optional)

Instructions

1. Prepare your tiles. Wipe the tiles clean with a damp cloth to remove any dust or dirt. Let the tiles dry completely.

2. Cut your photos. Cut your photos to be the same size as the tiles. You can use a ruler and pencil to mark the lines where you want to cut, then use scissors to cut the photos out.

3. Apply Mod Podge to the tiles. Use a foam brush to spread a thin layer of Mod Podge onto the front of each tile. Be sure to cover the entire tile, including the edges.

4. Place the photos on the tiles. Center the photos on the tiles and press them down firmly. Make sure that the photos are smooth and free of bubbles.

5. Apply a second coat of Mod Podge. Use a foam brush to spread a second thin layer of Mod Podge over the photos. Be sure to cover the entire photo, including the edges.

6. Let the tiles dry completely. Allow the tiles to dry for at least 24 hours before using them.

7. Add felt (optional). To protect your furniture, you can add felt to the bottom of the tiles. Cut the felt to the same size as the tiles and glue it on with super glue.

8. Enjoy your new tile photo coasters! Use your new coasters to protect your furniture from drink rings. They also make great gifts!

Tips

* Use high-quality photo paper for best results.

* Be sure to cut the photos to the same size as the tiles.

* Apply the Mod Podge in thin layers.

* Allow the tiles to dry completely before using them.

* If you want to protect your furniture from scratches, add felt to the bottom of the tiles.