How to Manually Adjust High Strait-Line 120 Laser Levels

Introduction:

The High Strait-Line 120 laser levels are highly precise tools used for various construction and alignment tasks. These laser levels project straight lines, and achieving accurate alignments requires proper setup. In certain situations, you may need to manually adjust the laser beams. This guide will provide you with step-by-step instructions to manually adjust the high strait-line 120 laser levels.

Step 1: Prepare for Adjustments:

- Set the laser level on a stable and level surface near the area where adjustments are required.

- Ensure the laser level is fully charged or plugged into a power source.

Step 2: Locate and Identify the Adjustment Screws:

- Carefully inspect the laser level housing to locate the adjustment screws. Usually, there are two screws, vertically arranged on either side of the laser emitter.

Step 3: Adjust Horizontally:

1. To adjust the horizontal beam, use a small flat-head screwdriver to turn the left adjustment screw clockwise or counterclockwise.

- Turning the screw clockwise moves the beam to the right, while turning it counterclockwise moves the beam to the left.

- Make minor adjustments until the laser beam is aligned in the desired horizontal position.

Step 4: Adjust Vertically:

1. To adjust the vertical beam, use the flat-head screwdriver to turn the right adjustment screw clockwise or counterclockwise.

- Clockwise turns move the beam upwards, and counterclockwise turns move the beam downwards.

2. Make precise adjustments until the vertical laser beam aligns perfectly with your desired position.

Step 5: Final Check and Fine Tuning:

1. Verify your adjustments by projecting the laser beams onto a suitable surface, like a wall or the desired work area.

- If further adjustment is necessary, repeat steps 3 and 4 as required.

2. Allow the laser level to stabilize after each adjustment. The laser beams may take a brief moment to settle in their new positions.

Step 6: Secure the Adjustments:

1. Once you are satisfied with the alignment, ensure that the adjustment screws are securely tightened to avoid any unintended movements.

Step 7: Test and Validate the Alignment:

- Perform a thorough test by projecting the laser beams onto various target points or reference marks.

- Confirm that the laser lines remain aligned throughout the desired range.

Maintenance Recommendations:

- Regularly clean the laser emitter lens using a soft, dry cloth to ensure clear and accurate laser projection.

- Store the laser level in its protective carrying case when not in use to protect it from damage.

- Refer to the user manual provided by the manufacturer for additional information on maintenance and troubleshooting.

Conclusion:

By following these steps, you can successfully perform manual adjustments on your High Strait-Line 120 laser level, ensuring accurate alignments for your construction or alignment tasks. Remember, careful adjustment and proper handling of the laser level are essential for precise results. If you encounter any difficulties, consult the manufacturer's guidelines for additional support.