How to Operate a Hayward Pool Pump

Hayward pool pumps are designed to circulate water throughout your swimming pool, keeping it clean and free of debris. Operating a Hayward pool pump is a simple task that can be completed in just a few minutes.

Step 1: Turn on the power to the pool pump.

The power switch for your pool pump is typically located on the side of the pump. Flip the switch to the "On" position.

Step 2: Set the pump speed.

The pump speed can be adjusted by turning the dial on the side of the pump. The higher the pump speed, the faster the water will circulate through the pool.

Step 3: Open the pool valves.

The pool valves are located on the pipes that connect the pump to the pool. Open the valves to allow water to flow through the pump.

Step 4: Start the pump.

Press the "Start" button on the pump. The pump will start to circulate water through the pool.

Step 5: Monitor the pump.

The pump should run continuously for at least 8 hours per day. Check the pump regularly to make sure it is operating properly.

Step 6: Turn off the pump.

When you are finished using the pool, turn off the pump. Flip the power switch to the "Off" position.

Step 7: Close the pool valves.

Close the pool valves to stop water from flowing through the pump.

Tips for Operating a Hayward Pool Pump

* Always turn off the power to the pump before working on it.

* Never operate the pump without the pool valves open.

* Check the pump regularly to make sure it is operating properly.

* If the pump is not working properly, contact a qualified pool professional.