How to Make Raised Beds with Railway Sleepers

Calculate the number of sleepers you need for your raised bed. According to the Railway Sleeper website, the average sleeper size is 8 feet 6 inches long, 10 inches wide and 5 inches deep. The number of sleepers you'll need for your raised bed depends on the size of your desired bed. When calculating, remember that you need to make your bed at least four sleepers tall.

Arrange railway sleepers into a rectangle or square on the ground. If the sleepers need trimming, cut them to size using a circular saw or a chain saw.

Connect sleepers end-to-end using metal plate connectors. Center the metal plate connector over the gap where two sleepers meet and place a 4-inch timber screw into each hole to hold the plate in place. If you want your raised bed to be extra secure, place a second metal plate connector on the opposite side of the sleepers as well.

Attach railway sleepers to each other at the corners using a drill and 10- to 12-inch timber screws. Timber screws do not require pre-drilling and can bore directly through sleepers. Connect the corners by drilling two to three timber screws through the entire width of one sleeper, into the end of the adjacent sleeper.

Stack sleepers on top of the first set. Attach the sleepers to the bottom rectangle or square in the same way that you attached the bottom sleepers to each other, except drill the timber screws through the top sleepers into the bottom pieces. Also, connect the sleepers to each other as you did the first row, end-to-end.

Continue stacking sleepers on top of each other until your wall is at least 18 inches high, though it can be higher if you prefer. Continue to use timber screws to connect the sleepers to each other.

Fill the sleeper bed with garden soil to complete your growing space. Plant your flowers or vegetables according to the directions on the seed or seedling packages.