How to Replace a Foot Valve for Shallow Well

- New Foot Valve

- Adjustable Wrench

- Bucket or Container

- Screwdriver

- Pipe sealant

-Pliers

- Flashlight

Instructions:

1. Prepare the work area.

- Turn off the water supply to the shallow well by closing the main shutoff valve.

- Open a faucet near the well to allow any remaining water to drain out of the pipes.

- Place the bucket or container underneath the foot valve to catch any remaining water.

2. Remove the old foot valve.

- Use the screwdriver to pry loose the retaining screws on the top of the old foot valve.

- Carefully lift the old foot valve off the bottom of the well casing. Be careful not to drop it into the well.

3. Inspect the foot valve seat.

- Clean the foot valve seat using a wire brush or scouring pad to remove any debris.

- Check the seat for damage and replace the foot valve seat if it is damaged.

4. Install the new foot valve.

- Apply a layer of pipe sealant to the threads of the new foot valve.

- Carefully lower the new foot valve onto the foot valve seat.

- Tighten the retaining screws until the foot valve is snugly in place.

5. Test the foot valve.

- Turn on the water supply to the shallow well.

- Check for any leaks around the foot valve.

- If there are any leaks, tighten the retaining screws or apply a little more pipe sealant.

6. Replace the well casing cap.

- Replace the well casing cap and tighten it securely.

7. Turn on the water supply to the faucets.

- Open the faucet near the well and allow the water to run until it is clear of any air bubbles.

- Turn on any other faucets in the house as needed.

Your foot valve is now replaced, and your shallow well should be working properly again!