How to Decoupage a Photo on Wood

- Wooden plaque or board

- Photo

- Mod Podge

- Scissors or craft knife

- Paintbrush

- Sponge or cloth

- Sandpaper (optional)

- Clear coat spray (optional)

Instructions:

1. Prepare the wooden plaque or board. If the wood is rough, sand it smooth. Wipe the wood clean with a damp cloth.

2. Print the photo. Print the photo on high-quality paper. Make sure the photo is the same size or smaller than the wooden plaque or board.

3. Cut out the photo. Cut the photo out carefully with scissors or a craft knife.

4. Apply Mod Podge to the back of the photo. Use a paintbrush to apply a thin layer of Mod Podge to the back of the photo.

5. Position the photo on the wooden plaque or board. Carefully place the photo on the wooden plaque or board, making sure it is centered.

6. Apply Mod Podge over the photo. Use a paintbrush to apply a thin layer of Mod Podge over the top of the photo.

7. Let the Mod Podge dry. Allow the Mod Podge to dry completely, following the instructions on the Mod Podge bottle.

8. Sand the edges of the photo (optional). If desired, you can sand the edges of the photo to create a smooth finish.

9. Apply a clear coat spray (optional). To protect the photo, you can apply a clear coat spray.

Your decoupaged photo on wood is now complete!