Ensure the area to be repaired is completely dry by using the low setting on your hair dryer to prepare the surface for gluing.
Mix the two-part epoxy in the small tray included in the kit. There will be two tubes containing ingredients that must be carefully combined, following kit directions.
Apply the prepared epoxy to the back of the chipped piece, using a toothpick.
Spread the glue thinly and evenly with a popsicle stick.
Place the chip in position by lining up the broken edges as precisely as possible.
Hold the chip in place for 30 seconds to allow the epoxy to set.
Apply porcelain enamel with a new toothpick to fill in any visible cracks that may remain at the site of repair.
Smooth the surface with an unused popsicle stick.
Allow the repaired piece to dry for 24 hours.