How to Soundproof Stairs

Fix Creaks and Squeaks

• 1

  Locate squeaky steps and pull the treads -- the horizontal boards that you step on -- to inspect for cracks or separations. The front of the tread sits flat atop a riser -- the board that rises from one tread to the next -- and the back should sit snugly against the next riser. Plane off excess wood or insert shims to fill gaps.

• 2

  Apply thin beads of construction adhesive to the edges of stringers, riser and back edge of the tread before laying the tread back down. The adhesive will form a flexible seal between the wood surfaces that will deaden any creaks.

• 3

  Attach treads to the stringers and riser with deck screws instead of nails, which can slip. Run screws through shims and trim off the ends. Drill pilot holes -- starter holes of smaller diameter than the screws. Countersink the screws into the wood and glue wood buttons on top or fill the indentations with wood putty.

Cushion Impact

• 4

  Install carpet treads where you want wood stair treads and risers to show. Affix double-sided carpet tape to the back of individual tread-sized carpet sections and lay them on the treads. Staple or tack the corners down for added security.

• 5

  Put in stair runners to cover the tread and riser of the stairs. Beginning at the bottom, staple the runner across the base of each riser and under the nose of the tread above it. Stretch the runner back into the corner between the back of the tread and base of the next riser and staple to both the tread and riser. Add decorative rods to runners for a traditional look.

• 6

  Apply tack strips across the bottom of the riser and across the top just under the lip of the tread for wall-to-wall stair carpeting. Anchor a third strip on the tread in front of the riser base. Cut squares of carpet that cover one step each. Working from the bottom step up, tack carpet cut to size across the back of the tread, over the front of the tread, and onto the strip at the bottom of the riser. As you work, tuck the edges in along the sides and secure them with heavy-duty 1/2-inch staples. As you finish each step, conceal the edges by pushing them between the tack strips along the intersection of the back of the tread and base of the riser with a carpet tool -- a heavy, wide spatula used by carpet layers.