How to Make a Wire Arch

- 1/2 inch EMT conduit (10 feet)

- 1/2 inch conduit bender

- 1/2 inch conduit connectors (4)

- 1/2 inch conduit end caps (2)

- Wire cutters

- Pliers

- Safety goggles

- Tape measure

- Pencil

- Level

Instructions:

1. Measure and cut the conduit.

- Cut four pieces of conduit, each 2 feet long.

- Cut two pieces of conduit, each 3 feet long.

2. Bend the conduit.

- Bend the four 2-foot pieces of conduit into arches.

- To do this, place the conduit in the conduit bender and bend it to a 90-degree angle.

- Repeat this process on the other end of the conduit.

- Bend the two 3-foot pieces of conduit into straight pieces.

3. Assemble the arch.

- Connect the two arched pieces of conduit to the two straight pieces of conduit using the conduit connectors.

- Make sure that the arched pieces are facing each other.

- Tighten the conduit connectors securely.

4. Add the end caps.

- Attach the end caps to the ends of the two straight pieces of conduit.

5. Install the arch.

- Choose a location for the arch and mark the spots where the legs of the arch will go.

- Dig holes at the marked spots, deep enough to accommodate the legs of the arch.

- Set the arch in place and backfill the holes with dirt or gravel.

- Use the level to make sure that the arch is level.

Your wire arch is now complete! You can use it to add a decorative touch to your garden, patio, or wedding.